Rubicon Owners Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
245 Posts
Discussion Starter #1
I have kc lights mounted on the windshield hinges. where do you run the wires into the cab at? any ideas would be appreciated!
 

·
Registered
Joined
·
1,464 Posts
What mounts did you go with? I'm looking for the combo mirror/light bracket ones. I think the best way to run the wiring is down into the cowl/engine area and then into the cab through the giant rubber grommet I stick everything through below the steering wheel. Actually, there shouldn't be wiring from the light into the cab, you should have wiring from a switch to a relay ( usually in the engine compartment) and then a connection between the battery and the light via the relay. Personally, i would use 2 relays, one for each light.
 

·
Registered
Joined
·
282 Posts
I ran mine under the cowl. There are only 5 screws holding it down.From there I went to the engine compartment and to the relay
 

·
Registered
Joined
·
556 Posts
Beware....mine ahve been giving me trouble. Burning out relays like crazy. Make sure your lamps arent grounding themselves. Good luck!
 
1 - 4 of 4 Posts
Top