Rubicon Owners Forum banner

1 - 3 of 3 Posts

·
Premium Member
Joined
·
1,184 Posts
Discussion Starter #1
I know this has been covered before, but I am still confused.
My trires rub on the LCAs at full turns. I have read that I just need to add washers to keep the wheels from turning too far.
What is the location of these bolts to place the washers. I was looking at the back of the wheel area, but didn't see anything that might be the right place.

Any good descriptions or pics would be most appreciated.

Thanx,
Brian
 

·
Premium Member
Joined
·
3,745 Posts
You have to look near the bottom of the front of the spindle.



Jerry
 

·
Premium Member
Joined
·
1,184 Posts
Discussion Starter #3
Perfect. Thanx so much.
 
1 - 3 of 3 Posts
Top