Rubicon Owners Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
188 Posts
Discussion Starter #1
I recently installed the RE BB on my Rubi, my question is, the directions say to take the factory isolator pads out. (rear is a flat rubber one) and to do the same in the front. However, the front on is like 1/2 an inch thick. So I still did what they said, and now my front saggs lower than the rear. The spacers were the same size for the F&R so how is RE figuring the 1/2 extra needed will come from?

What did you RE people do?
 
1 - 4 of 4 Posts
Top