Rubicon Owners Forum banner

1 - 4 of 4 Posts

·
Premium Member
Joined
·
4,195 Posts
Discussion Starter #1
Ok, im on the last leg of my install......which is setting the pinion angle. I talked to MShelton on the phone and he explained in great detail how to set the pinion angle(thanks), but I was wondering if anyone had any pictures or drawings of where I need to put my angle finder and how to do this. Thanks in advance!
Pete M
 
G

·
Guest
Joined
·
0 Posts
The guy that helped me, put a simple laser pointer into the diff side, pointed it right at the t-case flange, then lowered it 2 degrees.

I got a ton of lift on the shart arm kit, and my rig runs saawwweeettt.
 
G

·
Guest
Joined
·
0 Posts
Here is the link to a copy of the FSM page to set your pinion angle. Instead of the protractor that they used, just find a socket that will fit inside to the cap and hold your angle gauge to that. My Pinion and T-case are set at about 1/2 degree off, Pinion lower. No vibes, but the DS is at a bad angle. Remember the front is a Double candan, so the pinion and DS need to be at the same angle.

Drive Shaft Angle

Ron
 
1 - 4 of 4 Posts
Top