Rubicon Owners Forum banner

1 - 12 of 12 Posts

·
Premium Member
Joined
·
3,968 Posts
Discussion Starter #1 (Edited)
Just a little while back I asked a question about adding a switch to an existing light circuit near a new future door . Thought I'd share the progress so far...

The wall.... I'll be getting power from that outlet for another new outlet and an exterior light. Exterior light was suggested by FLLJ

74205


Stud removal....

74206


Door framed in...… sill plate will be removed when the hole is cut for the door.

74207


Running 12/3 for three way switch to existing light switch....

74208


12/3 over to new three way switch by new door.... 50 feet across the ceiling from other switch.

74209


Closed up holes in ceiling...

74212

Making connections... in the dark...

74210


Both ends of new three way switch circuit done... it works! Yeah, I got a hole to patch at existing switch side. The second switch at new door side is for a future outside light.
When I cut a hole in the wall and install the door I'll post more pics if ya'll want. Probably won't happen until June.

74213


74214
 

Attachments

·
Moderator
Joined
·
3,356 Posts
Looks good.
 

·
Premium Member
Joined
·
3,968 Posts
Discussion Starter #5
Thanks for the comments... a couple last things until it warms up and I can cut a hole in the wall to install door....

Reinforced sill plate to foundation on both sides where it will be cut out for door... this door frame is NOT moving!

74219


Wiring for new outlet completed... all wiring done except installing outside light....

74220
 

·
Administrator
Joined
·
10,556 Posts
That's an interesting place for an outdoor light. With our house remodeling and addition (and a new detached garage) I went to all LED motion floods. This is the one in the front of the garage, very bright and the motion sensor works quite well.
 

·
Registered
Joined
·
391 Posts
That's an interesting place for an outdoor light. With our house remodeling and addition (and a new detached garage) I went to all LED motion floods. This is the one in the front of the garage, very bright and the motion sensor works quite well.
I was going to post a similar comment (with a sarcasm emoji) but couldn't find an appropriate one.

I've found that lights near a man door on attached garages are beneficial, as long as they are on the handle side of the door, to allow the light to be turned on when opening from the inside before the motion sensors activate.

Thanks for the link to the LED light.
I have 10 year old halogen lights that are now requiring sensor and lamp repairs.
 

·
Moderator
Joined
·
3,356 Posts
Do you plan to pour a concrete pad outside the door?
 

·
Premium Member
Joined
·
3,968 Posts
Discussion Starter #11
Do you plan to pour a concrete pad outside the door?
Yes... The foundation is about four inches above the floor level and as I don't plan on cutting that out, there will be a slight step to get over at the threshold. A pad outside and small wood step inside will alleviate that a little.

Someday I need a pad in my driveway!
 
1 - 12 of 12 Posts
Top