Rubicon Owners Forum banner

1 - 14 of 14 Posts

·
Moderator
Joined
·
3,634 Posts
Discussion Starter #1
I haven't used it much since it became an almost dedicated trail rig, so its better someone else gets the use of it. 2004 TJ.

The servo and steering wheel buttons for the cruise control is whats up for sale - should be everything to make it work. TJs of this era should have the factory wiring installed (tied up under the brake master cylinder).

$100.

Located in Shreveport, LA
 

·
Registered
Joined
·
30 Posts
Still for sale?
 

·
Moderator
Joined
·
3,634 Posts
Discussion Starter #3
Only to a good home.
 

·
Registered
Joined
·
669 Posts
for what its worth, not ALL TJ's are prewired for cruise, however it seems all rubi's ARE prewired. I learned this the hard way after junkyard scalping the parts to add cruise to my 05 LJ rubi, then attempting to do the same on my gf's 05 TJ sport since it was soo easy on mine. I get the parts only to find hers is not prewired. :banghead:
 

·
Registered
Joined
·
30 Posts
What do I need to look for to know if mine is pre-wired??
 

·
Registered
Joined
·
669 Posts
like he mentioned, look for a plug taped back onto the harness near the brake master cylinder.
 

·
Registered
Joined
·
10 Posts
PM sent...
 

·
Jeepless in PA
Joined
·
12,587 Posts
Cub said:
What do I need to look for to know if mine is pre-wired??
Or unscrew the cover plates on the steering wheel and see if there is a wire. (philips screw)
 

·
Registered
Joined
·
30 Posts
I didnt see a plug near the master cyl...guess im out of luck :(
 

·
Premium Member
Joined
·
3,769 Posts
Ill try to dig up the instructions tomorrow on installing the cruise tomorrow. That should help anyone with locating the proper plugs.
 

·
Moderator
Joined
·
3,634 Posts
Discussion Starter #11

·
Registered
Joined
·
10 Posts
pghsteel said:
Ill try to dig up the instructions tomorrow on installing the cruise tomorrow. That should help anyone with locating the proper plugs.
pghsteel,
This information would be most appreciated. Thanks
 

·
Premium Member
Joined
·
3,769 Posts
vrodb said:
pghsteel said:
Ill try to dig up the instructions tomorrow on installing the cruise tomorrow. That should help anyone with locating the proper plugs.
pghsteel,
This information would be most appreciated. Thanks

What's your e-mail? I have it scanned as a PDF. I can't attach that to the board.
 

·
Registered
Joined
·
10 Posts
1 - 14 of 14 Posts
Top