Rubicon Owners Forum banner

1 - 2 of 2 Posts
G

·
Guest
Joined
·
0 Posts
Discussion Starter #1
Does anyone know the dimensions of the transfer case output shaft flange ?

My local driveline shop says that they can supply a CV shaft, but would need detailed dimensions of the flange. ie; bolt hole pattern, center alignment hole size, and if it sticks in or out.

Thanks!

PS: Has anyone located a good (and not too expensive) source of CV driveshafts for Rubicons?
 

·
Registered
Joined
·
1,530 Posts
If you are going to get a CV you may want to remove the stock output configuration all together and install a Spicer Yoke...Part # 2-4-5441 this will make it much easier to get a CV.

Here is a pic of the conversion part....There is a little machining that needs to be done. If anyone is interested I can give you details just PM me. I plan to do a write up on it next week when I get my DS

 
1 - 2 of 2 Posts
Top