Rubicon Owners Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Installing CV Drive shaft on '05 w/3.5" superflex lift by RE w/ adjustable upper arms.

- What is the torque spec on the 4 bolts attaching drive shaft to rear of transfer case ?
- What is the torque spec on the 4 bolts attaching the u-joint to the rear diff. ?
- What to do with E-brake cables that are held in place by a bracket bolted to the
stock upper control arms.
 

·
Premium Member
Joined
·
3,178 Posts
farmer said:
..................................................- What to do with E-brake cables that are held in place by a bracket bolted to the
stock upper control arms.
Can't answer your torque questions but for the cables............

 

·
Premium Member
Joined
·
1,563 Posts
I believe it is 85 ft/lbs or snug tight plus a half turn.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #5
Thank you very much for your information and quick response I am new to this with lots to learn, and trying not to learn the hard way.
 

·
Jeepless in PA
Joined
·
12,587 Posts
farmer said:
Thank you very much for your information and quick response I am new to this with lots to learn, and trying not to learn the hard way.

No problem, you're welcome. Feel free to post any question you may have. :)
 

·
Premium Member
Joined
·
3,178 Posts
You'll learn that Greg is one to trust here, as well, as many others. I try not to post up a guess when, I know he is lurking nearby.
 

·
Registered
Joined
·
582 Posts
If you are going to use lock tite, use blue, not red. I have used the blue with good results.
 
1 - 8 of 8 Posts
Top