Rubicon Owners Forum banner

1 - 2 of 2 Posts
G

·
Guest
Joined
·
0 Posts
Discussion Starter #1
Has anyone tried installing the currie steering system on a unlifted rubicon? If so, have you managed to get the toe-in set correctly?

I installed the kit but was unable to bring the toe-in back to spec...all the TRE's are bottomed out. A quick call to Currie verified that the kit should work on a unlifted '03 (despite what their instructions say). But I just don't see it happening.....the drag link is too long.

Has anyone else had the same problem?
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #2
Haven't tried Currie's on my Rubi yet, but I did get it for a Scrambler that I used to have - had the same problem.

Sent it back and they trimmed 1/2" off, then it worked fine. I would suggest you have them trim it or have a machine shop do it - do not try it with a saw. It must be machined down.

Cal
 
1 - 2 of 2 Posts
Top