Rubicon Owners Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
188 Posts
Discussion Starter #1
What did you guys use for your BL torque spec? I am installing the Daystar lift this week. Some guys say 40 ft lbs, some say 90? what do you all think.

Damon
 

·
Registered
Joined
·
556 Posts
Didnt have a torque wrench so I ran them up with the air wrench then hand tightened them a 1/2 turn or so. Sorry I'm not more specific. I would think 90 would compress the spacer and cause an awful lot of stress on those poor threads.
 
G

·
Guest
Joined
·
0 Posts
Here you go. These are the FSM specs.

MAIN FLOOR TO FRAME HOLD DOWN BOLT 68nm 50ftlb (6 under the door)
RADIATOR TO FRAME HOLD DOWN BOLT 60nm 45ftlb (1 in front)
REAR FLOOR TO FRAME HOLD DOWN BOLT 47nm 35ftlb (4 by the gas tank)

Ron
 

·
Registered
Joined
·
188 Posts
Discussion Starter #4
Thanks Ron, your the man....
 
1 - 4 of 4 Posts
Top