Rubicon Owners Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
759 Posts
Discussion Starter #1
After my lift install(RE 3.5 Standard) pass. side of the sway bar hits the frame. readjusted it with the pry bar and after flexing it a few more times the bar came back to the same position, hitting the frame. Anyone suffer from the same problem?
 
G

·
Guest
Joined
·
0 Posts
I have to assume that you either have a adj. front track bar, or you drilled the new hole 3/4" over. There have been a few people with similar problems. The fix was a set of clamps to go on the anti-sway bar inside of the frame mounts. Double check your axle centering, it may still be off.

Ron
 

·
Registered
Joined
·
759 Posts
Discussion Starter #3
Well i must have missed the 3/4" hole. Didn't know about that just might get the adjustable then.
 
1 - 3 of 3 Posts
Top