Rubicon Owners Forum banner

another stroker ?

914 Views 5 Replies 4 Participants Last post by  chris03rubicon
will the golen 4.7 stroker run fine with the stock pcm thanks guys im seriously considering it soon
1 - 6 of 6 Posts
The PCM will be fine, and you should use care to keep it happy by retaining all the stock sensors and wiring. You must however make changes to exhaust and intake to improve engine breathing. Then use a bored throttle body and larger capacity fuel injectors.
i was thinking full banks and a mcai
That sounds good. Then add a 62mm throttle body and a matched set of 24-lb injectors, and you will be good to go. Golen will sell you all the accessory parts.
it would run best on a aftermarket pcm but you well get by with no problems on stock
seal66 said:
it would run best on a aftermarket pcm but you well get by with no problems on stock
Aftermarket PCM??? Do you mean a chip or programmer?
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top